A cloudy pool lingered after every run. Part of a broken tumbler had wedged in the pump. Cleared and tested, it drains fully now.
Gritty plates, cloudy glasses, a puddle under the door, or water that never drains. Our technician finds whether it's the filter, pump or a seal and gets your dishwasher cleaning properly again.
Common Calls
Every common dishwasher fault in one view: what you'll see, why it happens, how we fix it, and what to do before we arrive.
| Problem | What You Notice | Likely Cause | What We Do | While You Wait |
|---|---|---|---|---|
| 01Won't Drain | Cloudy water stays in the tub after the cycle. |
Filter plugged, sink air gap blocked, or glass stuck in the pump. Drain pumpFilterAir gap |
Cheap suspects come first, filter and sink air gap, before the pump and hose are tested. |
Scoop out what's left in the tub before we get there. |
| 02Dirty Dishes | Plates come out gritty and glasses look filmy. |
Mineral scale in the spray arm holes, a weak wash pump or low water temperature. Spray armsWash pumpHeating element |
Descale or swap the arms, then measure circulation and water heat. |
Get hot water flowing at the faucet first. |
| 03Leaking | Water spreads across the floor below the door mid-wash. |
An aged door seal, a cracked spray arm, or a slack hose clamp beneath the unit. Door gasketHose clampsPump seal |
Find the exact leak point, then replace the seal or fitting. |
Note where the water appears: front, side or under the kickplate. |
| 04Not Drying | Dishes are clean but still wet at the end. |
A dead heating element, a vent flap that stays closed, or no rinse aid. Heating elementVent assemblyRinse aid dispenser |
Test the element and vent, and confirm the rinse aid dispenser works. |
Top up rinse aid and choose the heated-dry option. |
| 05Won't Start | The panel lights up but no cycle begins. |
Most often the door latch switch; less often a thermal fuse or the control board. Door latchThermal fuseControl board |
Testing goes in that order, cheapest first. |
Switch its circuit off for five minutes, then on again. |
| 06Grinding | A harsh grinding noise mid-wash. |
Something hard, like a pit or glass, has reached the chopper or pump. Chopper bladeWash pumpImpeller |
Remove the object and check the impeller for damage. |
Stop the program and look for glass or pits in the filter. |
From the builder-grade units in new Hays County subdivisions to premium kitchen suites, our technicians work on every major make you'll find in a Buda home.
Don't see your brand? Call us anyway; chances are we repair it too.
Choose your brand to see the codes that make most often shows. Meanings may shift slightly between model years.
Bosch reports a drain problem; look for a blocked filter or bent hose.
Water has been detected in the base pan.
The filter is clogged and needs cleaning.
Drain time exceeded, often a kinked hose or blocked filter.
Leak sensor triggered under the tub.
Not enough water is entering the dishwasher.
The dishwasher isn't draining properly.
A leak has been detected in the base.
Samsung sees too little incoming water, often a shut valve.
Code still showing after a five-minute power cut? Then book a technician for a proper diagnosis.
Feedback from Buda households after a dishwasher visit.
A cloudy pool lingered after every run. Part of a broken tumbler had wedged in the pump. Cleared and tested, it drains fully now.
Glasses were coming out cloudy. Spray arms were full of scale. Cleaned and spotless again.
Slow drip along the door. Seal came on order, second trip, floor's dry.
Dishes always came out wet. Dead heating element replaced.
Lights on but nothing started. Door latch switch had failed. One visit.
Grinding mid-wash. Turned out to be an olive pit near the chopper. Removed, pump fine.
Work through these before booking; some dishwasher calls end here.
Clean the filter
Lift out the lower rack, twist the filter free and wash it in the sink. A clogged filter causes poor draining and dirty dishes.
Clear the air gap
Lift the small cap next to your faucet and clear any gunk. A blocked air gap stops draining.
Run the hot tap
Start the faucet running hot before pressing start. Cold water at the start hurts cleaning.
Spin the arms
Turn each spray arm by hand to check nothing blocks it. Tall pans often get in the way.
Add rinse aid
Keep the dispenser filled. It's the simplest fix for wet, spotty dishes.
Latch the door
Push the door until the latch audibly catches. Many models won't start otherwise.
Still not working after all six?
Book A VisitDrop your name and number below, and someone from our office will ring you to set a time. Let us know the make and what's going wrong so the technician brings the right parts.
Thank You!
Your message has been sent successfully. We'll get back to you shortly.
Thank You!
Your message has been sent successfully. We'll get back to you shortly.